Ex-500.com - The home of the Kawasaki EX500 / Ninja 500R banner
Cancel
Create thread New Forums

Removing damper rod from 1st gen forks...

Jump to Latest
1.5K views 3 replies 4 participants last post by  Rayycc1  
C
#1 ·
I read the wiki and followed all the steps but I just can't get the damn things out. One turns, but doesn't come out smoothly, so I assume it's just turning the rod itself. I know there are tips to make this easier...

Can I get the forks out as is and deal with the damper rod while they're in a vise?
 
F
#2 ·
You need a long rod or dowel to hold the damper in place from the inside.
Tip break those screws loose when the forks are fully assembled. DO not put any downward pressure on the wrench .

FOG
 
R
#4 ·
I have found that a wooden broom handle with a slight taper works well for this...just put it in the tube and give it a little wack with a hammer to get the tube to bite the wood...they should come out after that.
 
Ex-500.com - The home of the Kawasaki EX500 / Ninja 500R
posts
765K
members
29K
Since
2006
A forum community dedicated to Kawasaki Ninja EX 500 sportbike owners and enthusiasts. Come join the discussion about modifications, cafe racers, racing, classifieds, troubleshooting, accessories, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Discussion Modifications & Upgrades Troubleshooting Engine Other Motorcycle Talk